The next step is to create the cutouts where the doors will go. The cutouts are nothing more than white filled rectangles that cover the wall where the doors go and are added to make the walls invisible in that location.
The following diagram was created (also done as an additional layer within the TouchDraw drawing) to provide a guide as to where the cutouts should be placed:
For this type of work, it is often best to zoom in on the area where the work will be performed. Zoom in on the front door and foyer closet portion of the drawing since the cutouts for these areas will be added first. To zoom in on a drawing, either open the View Menu and select the Zoom In option, select a zoom percentage in the Bottom Bar,, or use the Zoom Rectangle Tool in the Drawing Toolbar.
First, the front door is 5 feet from the left and a temporary line must be drawn to be used as a point of reference.
Next, use the Rectangle Tool to draw the cutout.
The rectangle was drawn with the current stroke setting (which was 6 points and black), so a few stroke attribute changes will be necessary before continuing.
The Stroke Color may also be changed through the Format Bar by clicking on the Stroke Color Button and selecting white.
After the Stroke Color has been changed to white, you will see that our cutout is now styled correctly (with a white stroke and a white fill).
Next, duplicate the cutout and drag the copy to where the foyer closet door should go. To duplicate a shape, first make sure it is selected and then either click on the Edit Menu or perform a Control/Click combination anywhere on the drawing canvas to bring up the Contextual Menu and select the Duplicate option.
This action will create a duplicate that is slightly offset from the original.
Then click within the bounds of the copy and drag it to where the foyer closet door should go.
You will notice that the cutout has been centered within that wall; however, it will need to be made smaller as that door should be 2ft 6in. For this adjustment, the easiest thing to do is to click on the left center handle and move it over 3 inches and then click on the right center handle and move it to the left 3 inches.
Note: At this zoom level there is a grid stop every 3 inches (1/4 of a foot), which makes the above adjustment easy. If we were to zoom in further, grid stops would appear every 1 inch.
Next, move onto the side door. As seen in the example above, this door is 11 ft 7 in from the lower left hand corner. Since a temporary line already exists on the drawing, we'll just drag the handles and re-use it for the side door as well.
At the current zoom level, the line can be dragged up 11.5 ft (11 ft 6 in); however, we'll need to zoom in more to extend that temporary line the final 1 inch.
As the temporary line is dragged, you can look at the info bar that pops up to make sure it is dragged to the correct length.
Next, create the cutout rectangle for this door using the Rectangle Tool.